INTERIOR CUTTING DIES
 

1. Tool Steel
2. Supplies
3. Preparation
4. Layout Fluids
5. The Design
6. Clamp Plates
7. Drill Holes
8. Taper Holes
9. Thread Holes
10. Attach Plates
11. Drill Access Hole
12. Cut Interior Die
13. Two Methods
14. Stripper Plate 1
15. Stripper Plate 2
16. Make the Hinge
17. Cut Exterior Die
18. Assemble Plates
19. Final Alignment
20. Bend top Plate
21. Bend Bottom Plate
22. Heat Treating
23. Blanking
24. Notes
25. General Info

INTERIOR CUTTING DIES
Taper Holes back | next

Unbolt the plates, and using the #3 combination drill & countersink, drill the tapered seat into the BARE STEEL SIDE of the cold rolled steel, using the #43 drilled holes as a guide. Be sure that you do not go too deep with this. There should be about 1/64" (.4mm) of straight diameter left before starting the tapered portion.
Download Catalogue
© Copyright 2006 Bonny Doon Engineering, Inc. All rights reserved.