Hydraulic Die Forming Discussion Group
Re^7: What about UHMW for guide rings?
Jim Binnion
jbin@well.com
Cindy one other possibility is Viton or Silicone Rubber "O" rings as they may may be sliperier than the standard nitrile "O" ring. The other thought is that lard may not be the right lubricant to allow for ease of movement of the guide rings when they are being drawn out the other thought I had was to put a small amount of oil below the lower "O" ring to help push it out during drawing. See thew attached drawing
![[ Previous ]](../ceilidh-icons/ceil_prv.gif)
![[ Next ]](../ceilidh-icons/ceil_nxt.gif)
![[ Index ]](../ceilidh-icons/ceil_ind.gif)
Mon Nov 11
![[ Reply ]](../ceilidh-icons/ceil_rep.gif)
![[ Edit ]](../ceilidh-icons/ceil_edt.gif)
![[ Delete ]](../ceilidh-icons/ceil_del.gif)