Ceilidh ... Re^2: It's Been a While

Hydraulic Die Forming Discussion Group

Re^2: It's Been a While

Neil George
ngeorge@cymro-jewelworks.com

On Thu Sep 19, Phil Poirier wrote
---------------------------------
>>Neil,
>some nice images! Any chance you could post a schematic of the same die set? This would give people an idea of the several processes taking place.
>Thanks again for posting to the group,
>Phil
>
>
>On Mon Sep 9, Neil George wrote
>-------------------------------
>>Dear All,
>>It's been a while since I posted, and my only excuse is that I have been very busy. I thought I would post a picture of a die I built for punching holes, then coining and then blanking within the same setup. You might find it interesting even educational so here goes.

Phil,
Thanks. As soon as I can. All of the drawings where done in 2D, toolpathed and cut. For most individuals, it would not make sense to them as to what they are looking at, because when everything is drawn up, it is drawn to take advantage of machining strategies where geometry will be specifically created to generate a specific toolpath. I will convert to 3D as soon as I can, which will be tough at the moment because the new 3D laser machining centre is arriving in 2 weeks, and I have 200 pieces for Lufthansa to machine out by the end of the month.
Best Regards.
Neil George
954-572-5829

Mon Sep 23