Lee Marshall
lmarshal@bonnydoonengineering.com

This is a slightly wider frame than the standard 20 ton press and it is also 4" taller. This was done to enable it to accept the 6" Master Die Set. Previously, this could only be used in the 50 ton press (not because of the tonnage, but because it was large enough). That made it pretty expensive for someone that wanted to use the deep-draw set, but didn't need the extra tonnage. Also, it can be shipped by UPS.

To make it interchangable with all of the standard functions of the
regular 20 ton press, it comes with a 4" tall riser block that sits on
the bottom platen. It is 6" square, and it makes the press (for all
practical purposes) the same as the one that we have been selling for
the last 14 years. The lower platen has two holes that locate the block so that it can't get out of location.

It gives quite a bit of "upward mobility" for people that might think
about getting into deep draw at a later date.

Here are the part numbers and prices:

125.599 20T-6"MDS press with electric pump $1995.00
       ships by UPS in four boxes
       press frame 77#
       riser block 16#
       elec. pump  28#
       ram         28#

125.600 20T-6"MDS press with gauge $795.00
       ships by UPS in three boxes
       press frame 77#
       riser block 16#
       jack with gauge 40#

The first image shows both the 3" and the 6" deep draw sets alongside the press. They are not included in the above prices.

Lee

20T-6"MDS press frame